F-CO TAPE No.2 is a self-bonding tape which is used for electrical insulation with easy application.
F-CO TAPE No.2 has been won international recognition as a good insulating tape for more than 30 years. F-CO TAPE No.2 has excellent adhesiveness and insulation property.
Meet to *JCAA D 004
(Note)JCAA:Japan Power Cable Accessories Association
F-CO Tape No.2
Use
100V to 33kV cables
- To insulate the end of high voltage cables, electric wires and cable joints
- To repair the cracks of insulator of cables for high voltage and electric wires
- To protect insulation cover and clamp cover from water and slip down
Structure/Material
Properties
| Item | Property | |
|---|---|---|
| Tensile strength N/mm2 |
Normal | 2 or over |
| After heat aging | 2 or over | |
| Elongation % | Normal | 350 or over |
| After heat aging | 300 or over | |
| Volume resistivity Ω-cm(20°C) |
1×1015 or over | |
| AC breakdown strength kV/mm |
30 or over | |
| Shear adhesive strength N/20mm |
20 or over | |
| Ozone resistance | Good | |
| Tracking resistance | Good | |
| Water resistance | Good | |
(Note)These are measured values and not guaranteed.
Size/Packing unit
| Thickness (mm) |
Width (mm) |
Length (m) |
Packing unit (rolls) |
|---|---|---|---|
| 0.5 | 20 | 10 | 100 |
How to use
- Wind the tape half-lapped, with the adhesive side inside, stretching it evenly to the extent that its original width is reduced to about 10% (its width decreases by 1-2mm).
- Do not stretch the tape too much. In cold season, warm up the tape (+5°C+30°C) before application.
(Note)To improve the product, the specifications may be changed without any notice.