interface ewan 1 ip mtu 1500 ip address 192.168.1.1 255.255.255.0 exit interface lan 1 ip address 192.168.0.1 255.255.255.0 exit end
設定内容 | 画面表示例 |
---|---|
特権ユーザモードへの移行 パスワードの入力 設定情報の初期化 設定モードの変更 設定入力 ※ 設定保存 装置再起動 |
Router>enable Enter password: Router# Router#clear working.cfg Router# Router#configure terminal Router(config)#interface lan 1 Router(config-if lan 1)#ip address 192.168.0.1 255.255.255.0 Router(config-if lan 1)#exit Router(config)# Router(config)#interface ewan 1 Router(config-if ewan 1)#ip address 192.168.1.1 255.255.255.0 Router(config-if ewan 1)#ip mtu 1500 Router(config-if ewan 1)#exit Router(config)# Router(config)#end Router# Router#save SIDE-A % saving working-config % finished saving Router#reset Going to reset with SIDE-A.frm and SIDE-A.cfg. Boot-back not scheduled for next boot. Next rebooting firmware SIDE-A.frm is fine. Are you OK to cold start?(y/n)y |
LANインタフェースの設定状態を確認します。
確認内容 | 画面表示例 |
---|---|
LAN の設定状態を表示 IP アドレス等の確認 |
Router>show ip interface lan 1 LAN is up IPv4 is enabled IP address is 192.168.0.1, subnet mask is 255.255.255.0 Broadcast address is 192.168.0.255 MTU is 1500 bytes ・ ・ ・ |
EWANインタフェースの設定状態を確認します。
確認内容 | 画面表示例 |
---|---|
EWAN の設定状態を表示 IP アドレス等の確認 |
Router>show ip interface ewan 1 EWAN1 is up IPv4 is enabled IP address is 192.168.1.1, subnet mask is 255.255.255.0 Broadcast address is 192.168.1.255 MTU is 1500 bytes ・ ・ ・ |
ルーティング情報を確認します。
確認内容 | 画面表示例 |
---|---|
ルーティング情報の表示 *が表示されていることを確認 *が表示されていることを確認 |
Router>show ip route Max entry: 10000 (Commonness in IPv4 and IPv6) Active entry:3 (IPv4), 2 (IPv6) Peak:3 Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF B - BGP, I - IKE, U - SA-UP, D - REDUNDANCY, E - EventAction A - AutoConfig, > - selected route, * - FIB route, p - stale info. C> * 127.0.0.0/8 is directly connected, LOOP0 C> * 192.168.0.0/24 is directly connected, LAN C> * 192.168.1.0/24 is directly connected, EWAN1 |