Start of page




AQUALEX Menu starts

AQUALEX Menu ends


Main Content starts

Structural Design

AQUALEX

Applications

  1. Clean water supply / Simplified water supply systems
  2. Sewerage system
  3. Agricultural water system
  4. High pressure water supply / distribution systems
  5. Supply / Distribution systems for various liquids

AQUALEX Standard Type Cross Section


* A double armor type with increased strength is available for rocky bottoms where the pipes cannot be buried.

photo of AQUALEX
Maximum operation pressure : 1MPa

Standard specifications (Operation pressure: 1MPa)

*Specifications for higher operation pressure (above 1MPa) are available upon customer request.

Nominal diameter (mm) 50 65 75 100 125 150 175 200 225 250
Polyethylene pipe inner diameter (mm) 50 65 75 100 125 150 175 200 225 250
Polyethylene pipe wall thickness (mm) 5 6.5 7.5 10 12.5 15 17.5 20 22.5 25
Stainless steel tape thickness (mm) 0.2 0.2 0.2 0.3 0.3 0.4 0.4 0.5 0.5 0.5
Galvanized steel wire φ(mm) 6 6 8 8 8 8 8 8 8 9
(unit) 36 43 39 47 59 70 81 93 104 103
Protection layer thickness (mm) 4 4 4 4 4 4 4 4 4 4
Overall diameter Approx (mm) 86 104 120 150 180 210 240 271 301 333
Approximate weight (Vacant weight) Approx (kg/m) 11 15 21 28 36 45 54 65 74 92

These products have performance satisfying the JIS K 6762 requirements for double wall polyethylene pipes for water supply.

Top of Page

Main Content ends


Sub Category Menu starts

Sub Category Menu ends


End of page